Positioning The Deluxe Seat - Toro 31236 Operator's Manual

Changing the Back Position
You can adjust the back of the seat to provide a comfortable
ride. Position the back of the seat where it is most
comfortable.
To adjust the back of the seat, turn the knob, located under
the right-side armrest, in either direction to provide the best
comfort (Figure 11).
Changing the Lumbar Support
You can adjust the back of the seat to provide a customized
lumbar support for your lower back.
To adjust the back of the seat, turn the knob, under the
left-side armrest, in either direction to provide the best
comfort (Figure 11).

Positioning the Deluxe Seat

Figure 13
1. Forward-/Rearward-adjustment
lever
2. Weight-adjustment lever
3. Backrest-locking lever
Changing the Weight Adjustment
You can adjust the seat to provide a smooth and comfortable
ride.
Important: To adjust the seat for your weight, you
must sit in the seat and move the ignition key to the O
position.
Adjust the seat for your weight by pulling or pressing the
weight-adjustment lever (Figure
Your weight is adjusted correctly when the arrow is in the
middle clear area of the viewing window.
Within this viewing area, you can adjust the seat to minimize
the spring movement.
4. Armrest-adjustment knob
5. Lumbar-support-adjusting
knob
13).
When you have set the minimum/maximum weight
adjustment, you can hear it reaching the upper or lower end
stop.
Important: To prevent injury to you or damage to the
machine, check the setting for your weight and the seat
and adjusted it before you operate the machine.
Note: To avoid damaging the compressor during the weight
adjustment, do not operate the compressor longer than 1
minute.
Changing the Seat Position
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
1. Lift the lever to unlock the seat
2. Slide the seat to the desired position and release lever
to lock it into position.
3. Verify that the seat has locked into place by attempting
to move it back and forth.
Note: Do not operate the locking lever while
operating the machine.
Changing the Lumbar Support
The lumbar support increases both your seating comfort and
performance.
You can adjust the back of the seat to provide a customized
lumbar support for your lower back.
By turning the adjustment knob upward, you can adjust the
curvature in the upper part of the backrest cushion. By
turning the knob downwards you can adjust the curvature in
the lower part of the backrest cushion
0 = No curvature
1 = Maximum curvature at the top
2 = Maximum curvature at the bottom
Adjusting the Armrests
You can fold back the armrests and adjust the height
individually.
To adjust the armrests for height, separate the round cap
(Figure 13) from the cover, loosen the hexagon nut (13 mm)
behind it, adjust the armrests to the desired position, and
N tighten the nut. Replace the cap onto the nut.
Do not install the armrest in the lowest position, as the seat
belt roller might not function properly.
Changing the Armrest Angle
You can adjust the angle of the armrests for your comfort.
To adjust the angle of the armrests, turn the adjustment knob
(Figure 13).
18
(Figure 13).
(Figure 13).