Trouble-Shooting; Helpful Hints - One for All URC-7540 User Manual & Code Book

Trouble-Shooting

Helpful Hints

Problem:
Red light does not blink
when you press a key?
The ONE FOR ALL does
not respond after
pressing a key?
The ONE FOR ALL does
not operate your
device(s)?
Your brand is not listed
in the code section?
The ONE FOR ALL is not
performing commands
properly?
Press a key but get the
wrong result?
Problems changing
channels?
You cannot control the
volume feature of your
Satellite, Cable
Converter or TV/Video
Combination unit.
Video not recording?
You're having problems
operating all the
functions of your device
Solution:
Replace batteries with 2 fresh,
new "AA" alkaline batteries.
Make sure you are using new
batteries and are aiming the at
your device.
A) Try all the codes listed for
your brand. B) Try the search
method on page 8.
Try the search method on page
8.
You may be using the wrong
code. Try repeating the Direct
Set-Up using another code
listed under your brand or start
the search method over again
to locate the proper code.
Hold MAGIC until the red light
blinks twice, then press 992
and the device key twice. You
will need to set-up your device
again. Try the codes for brand
or the search method on page 8.
Enter the programme number
exactly as you would on your
original remote.
Hold MAGIC until the red light
blinks twice. Then press 993
then Vol+. To set the Volume
back to TV (Punch-Through),
hold the MAGIC until the red
light blinks twice, then press
993 TV.
As a safety feature on your ONE
FOR ALL, you must press the
Record key twice.
The ONE FOR ALL may just
need customising for your
model type. Just call our
consumer help-line and we'll
get you on the right track.
30 30