Table of Contents
Advertisement
STEP 6:
Setting Up Your mio Voice
New subscribers for mio Voice will automatically be configured with
the service. The "VOICE" LED on the Residential Gateway will turn on
after 10 minutes upon successful configuration of your BroadBand
service. Thereafter, customers may proceed to connect their supported
telephones following the steps below.
Important
Please ensure that ALL analogue devices e.g. telephones and fax machines are
disconnected from wall sockets to optimize the performance. If the Voice 1 and
Voice 2 LED does not light up after 10 minutes, please power off the Residential
Gateway momentarily and turn it back on. It will take approximately 5 to 10 minutes
for a successful configuration.
Congratulations! You have
successfully installed mio
Voice.
6.1
Connect your supported telephone
to the telephone port on the
Residential Gateway using a Phone
Cable Cable (RJ11).
Continue with step 6.2 and 6.3 only if
you have 2 mio Voice subscriptions
6.2
Please insert a FXS Phone Splitter
to the Phone Cable (RJ11) before
inserting the telephone of the
Residential Gateway.
6.3
Connect
telephones to P1 and P2 ports
respectively for both mio voice
lines
your
supported
Advertisement
Table of Contents
