Installing The Full Bed - Toro 07385 Operator's Manual

Figure 32
1. Bed mounting plate
2. Cylinder rod end
3. Clevis pin
3. Remove the clevis pins securing the cylinder rod ends
to the bed mounting plates by pushing the pins towards
the inside (Figure 32).
4. Remove the lynch pins and clevis pins securing the
pivot brackets to the frame channels (Figure 32).
5. Lift the bed off of the vehicle.
CAUTION
The full bed weighs approximately 147.5 kg
(325 lb), so do not try to install or remove it by
yourself. Use an overhead hoist or get the help
of two or three other people.
6. Store the cylinders in the storage clips. Engage the
hydraulic lift lock lever on the vehicle to prevent
accidental extension of the lift cylinders.

Installing the Full Bed

Note: If the bed sides will be installed on the flat bed, it is
easier to install them before installing the bed on the vehicle.
Note: Ensure that the rear pivot plates are bolted to the bed
frame/channel so that lower end angles to the rear (Figure 33).
4. Lynch pin
5. Rear slots (Full bed)
6. Front slots (2/3 bed)
1. Left rear corner of bed
2. Vehicle frame channel
3. Pivot plate
CAUTION
The full bed weighs approximately 147.5 kg (325
lb), so do not try to install or remove it by yourself.
Use an overhead hoist or get the help of two or three
other people.
Note: Ensure that the spacer brackets and wear blocks
(Figure 34) are installed with the carriage bolt heads
positioned inside the machine.
1. Spacer bracket
2. Wear block
1. Ensure that the lift cylinders are fully retracted.
2. Carefully set the bed onto the vehicle frame aligning
the rear bed pivot plate holes with the holes in the rear
35
Figure 33
4. Clevis pin
5. Lynch pin
Figure 34
3. Carriage bolt