Installing The Grass Bag; Bagging The Clippings - Toro 20797 Operator's Manual

Figure 19
1. Lever
Note: To unlock the plug, rotate the lever on the plug to the
right (Figure 19).

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
WARNING
A worn grass bag could allow debris to be thrown
and result in serious personal injury or death to the
operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side-discharge chute is on the machine,
remove it and lock the side-discharge door; refer to
Removing the Side-discharge Chute (page 13) before bagging
the clippings.
2. Tabs
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.

Installing the Grass Bag

1. Route the starter rope around the lower-rope guide
(Figure 20).
1. Lower-rope guide
Note: The lower-rope guide releases the starter rope
when you pull the recoil-start handle.
2. Raise and hold up the rear-discharge deflector
(Figure 21).
1. Rear-discharge deflector
3. Pull out the rear-discharge plug (Figure 21).
4. Hang the upper front edge of the bag on the notches
(Figure 22).
11
Figure 20
Figure 21
2. Rear-discharge plug