Adjusting The Cutting Height; Adjusting The Handle Height; Starting The Engine - Toro 20797 Operator's Manual

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set all 4 wheels to the
same height.
Note: To raise the machine, move all 4 cutting height levers
forward; to lower the machine, move them all rearward
(Figure 11).
Figure 11

Adjusting the Handle Height

You may raise or lower the upper handle to a position
comfortable for you.
Rotate the handle lock, move the handle to 1 of 3 positions,
and lock the handle into position (Figure 12).

Starting the Engine

1. Pull the blade-control bar to the handle (Figure 13).
2. Turn the ignition key (Figure 14) or pull the recoil-start
handle (Figure 15).
Note: When you pull the recoil-start handle, pull it
lightly until you feel resistance, then pull it sharply
(Figure 15). Allow the rope to return to the handle
slowly.
9
Figure 12
Figure 13