Daily Maintenance Checklist; Lubrication; Greasing The Bearings And Bushings - Toro 03706 Operator's Manual

Daily Maintenance Checklist

Duplicate this page for routine use.
Maintenance Check Item
Check the safety interlock operation.
Check the brake operation.
Check the engine oil and fuel level.
Check cooling system fluid level.
Drain the water/fuel separator.
Check the air filter restriction indicator.
Check the radiator, oil cooler, and screen for debris.
Clean traction pedal lockout
Check unusual engine noises.
Check unusual operating noises.
Check the hydraulic system oil level.
Check hydraulic hoses for damage.
Check for fluid leaks.
Check the tire pressure.
Check the instrument operation.
Check warning lamps operation
Check the reel-to-bedknife adjustment.
Check the height-of-cut adjustment.
Lubricate all grease fittings.
Touch-up damaged paint.
1. Check the glow plug and injector nozzles if hard starting, excess smoke, or rough running is noted.
2. Immediately after every washing, regardless of the interval listed
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.

Lubrication

Greasing the Bearings and
Bushings
If you operate the machine under normal conditions,
lubricate all grease fittings for the bearings and bushings
after every 50 hours of operation with No. 2 General
Purpose Lithium Base Grease. Lubricate bearings and
bushings immediately after every washing, regardless
of the interval listed.
For the week of:
1
2
Mon. Tues. Wed.
The grease fitting locations and quantities are as follows:
• Lift arms (5) (Figure 25)
27
Thurs. Fri.
Sat. Sun.