Sound Power Level; Sound Pressure Level; Vibration Level - Toro 03706 Operator's Manual

• Before disconnecting or performing any work on
the hydraulic system, all pressure in the system must
be relieved by stopping the engine and lowering the
cutting units and attachments to the ground.
• Check all fuel lines for tightness and wear on a
regular basis. Tighten or repair them as needed.
• If the engine must be running to perform a
maintenance adjustment, keep hands, feet, clothing,
and any parts of the body away from the cutting
units, attachments, and any moving parts. Keep
everyone away.
• To ensure safety and accuracy, have an Authorized
Toro Distributor check the maximum engine speed
with a tachometer. Maximum governed engine speed
should be 2900 RPM.
• If major repairs are ever needed or if assistance is
desired, contact an Authorized Toro Distributor.
• Use only Toro-approved attachments and
replacement parts. The warranty may be voided if
used with unapproved attachments.

Sound Power Level

This unit has a guaranteed sound power level of 105
dBA, which includes an Uncertainty Value (K) of 1 dBA.
Sound power level was determined according to the
procedures outlined in ISO 11094.

Sound Pressure Level

This unit has a sound pressure level at the operator's
ear of 86 dBA, which includes an Uncertainty Value (K)
of 1 dBA.
Sound pressure level was determined according to the
procedures outlined in EN 836.

Vibration Level

Hand-Arm
Measured vibration level for right hand = 0.38 m/s
Measured vibration level for left hand = 0.34 m/s
Uncertainty Value (K) = 0.5 m/s
Measured values were determined according to the
procedures outlined in EN 836.
Whole Body
Measured vibration level = 0.53 m/s
2
2
2
2
Uncertainty Value (K) = 0.5 m/s
Measured values were determined according to the
procedures outlined in EN 836.
7
2