Trouble-Shooting - One for All Little Easy User Manual & Code Book

Red light does not blink
when you press a key?
The ONE FOR ALL
does not respond after
pressing a key?
The ONE FOR ALL does
not operate your
device(s)?
Your brand is not listed
in the ONE FOR ALL
code section?
When following the set-
up instructions, the red
light on the ONE FOR ALL entering a new code. Follow the
only blinks once instead
of twice after you enter a
three-digit code?
The ONE FOR ALL
is not preforming
commands properly?
Press a key but get the
wrong result?
You cannot control the
volume feature of your
Satellite, Cable Con-
verter or TV/Video
combination OR
you cannot control the
volume of the TV set
up on the AUX key?
Problems changing
channels?
Video not recording?
Scan does not work on
your device?

Trouble-Shooting

Replace batteries with 2 fresh, new
AAA/LRO3 alkaline batteries.
Make sure you are using new
batteries and are aiming the
ONE FOR ALL at your device.
A) Try all the codes listed for your brand
B) Try the search method on page 10.
Try the search method on page 10.
Did you use the Code Lock feature?
You must first unlock the code before
instructions on page 19 to do this.
You may be using the wrong code.
Start the search method over
again to locate the proper code.
Hold MAGIC until the red light blinks
twice, then press 992 and the device key
twice. You will need to set-up your
device again. Try the codes for brand
or the search method on page 10.
Hold MAGIC until red light blinks twice
Then press 993 and VOL+. To set the
volume control back to TV (Punch-
Through), hold Magic until the red
light blinks twice, then press 993 TV.
Enter the programme number exactly
as you would on your original remote.
As a safety feature on your ONE FOR
ALL, you must press the Record key
twice .
Make sure your original remote had a
programme +/- key.
20