Motion Control Levers - Toro GrandStand 74534 Operator's Manual

3
G012705
1. Switch (on front side)
2. 1/8 inch (3 mm)
12. Tighten the switch screws.
Adjusting the Neutral Position for the

Motion Control Levers

Important: Ensure the tracking of the mower is
correct after adjusting the motion control levers.
Adjusting the tracking and aligning the motion
control levers front to back is the same procedure
(Figure 71).
Note: Adjust the horizontal alignment before the front
to back alignment.
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required.
1. After the horizontal alignment is finished, check
the front to back alignment by slightly pushing the
control levers forward to take up any slack in the
linkage for the control levers (Figure 71).
1 2
2
Figure 70
3. Right motion control lever
in the neutral unlocked
position
1
1. Left motion control lever
2. Right motion control lever
2. Ensure the right motion control lever moves easily
into the neutral lock position.
Note: Turn the cable adjustment clockwise to move
the motion control handle forward. Turn the cable
adjustment counter-clockwise to move the motion
control handle rearward.
3. Rotate the cable adjustment on right side when
adjustment is needed. Adjust the cable adjustment in
quarter-turn increments.
4. After the right motion control lever moves easily
into the neutral lock position, adjust the left motion
control lever to align with the right motion control
lever.
5. Check for proper tracking. Refer to Adjusting the
Tracking in the Maintenance Section.
48
2
G012706
Figure 71
3. Neutral locked position
4. Align the control levers
front to back
3
4