Starting And Stopping The Engine - Toro GrandStand 74534 Operator's Manual

1
2
G008948
Figure 15
1. On
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Move the right motion control lever to neutral
locked position.
4. Set the parking brake; refer to Setting the Parking
Brake.
5. Move the blade control switch (PTO) to the Off
position.
6. Move the throttle lever midway between the Slow
and Fast positions.
Note: A warm or hot engine may not require
choking.
g012703
2. Off
7. Turn the ignition key to the Start position
(Figure 13). When the engines starts, release the key.
Important: Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
1. Off
2. Run
18
Figure 16
G008947
Figure 17
3. Start