Stopping The Vehicle; Stopping The Engine - Toro 07205 Operator's Manual

Operating
1. Fuel filter/water separator
2. Air bleeder screw
3. Open the air bleed screw on the fuel injection
pump (Fig. 13) with a 10-mm wrench.
4. Turn the ignition key to ON. The electric fuel
pump will begin operation, forcing air out
around air bleed screw on fuel injection pump.
Leave the key in the ON position until a solid
stream of fuel flows out around the screw.
Tighten the screw and turn the key to OFF.
1. Fuel injection pump bleeder
DRIVING THE VEHICLE
1. Release the parking brake.
2. Fully depress the clutch pedal.
3. Move the gear shift lever to 1st gear.
4. Release the clutch pedal smoothly while depress-
ing the accelerator pedal.
5. When the vehicle gains enough speed, remove
your foot from the accelerator pedal, fully
20
Figure 12
Figure 13
depress the clutch pedal, move gear shift lever to
the next gear and release the clutch pedal while
depressing the accelerator pedal. Repeat this
procedure until desired speed is attained. Stop
the vehicle before shifting to reverse and for-
ward.
Note: Avoid long periods of engine idling.
Note: Leaving the ignition switch in the "ON"
position for long periods of time without
running the engine will discharge the
battery.
IMPORTANT: Do not keep the front wheels
turned against the right or left stops for
longer than 5 seconds. The hydraulic pump
may over heat, resulting in pump or steering
gear damage.
6. Do not push or tow the vehicle to get it started.
Damage to the drive train could result.

STOPPING THE VEHICLE

To stop the machine, remove your foot from the
accelerator pedal, depress the clutch pedal, then
depress the brake pedal.

STOPPING THE ENGINE

To stop the engine, turn the ignition key to OFF and
engage the parking brake. Remove the key from the
switch to prevent accidental starting.