Activate The Battery - Toro 70089 Operator's Manual

Assembly
5
6
7
Figure 3
1. Seat spacers (rubber)
2. Wire clamp
3. Seat switch wire
4. Locknut
5. Seat switch slot
6. Seat switch connector
5. Adjust seat to desired position in the seat base
slots and tighten locknuts and screws.
6. Insert seat switch connector into wire harness
connector.
7. Secure wire harness to front of seat base with
wire tie.

Activate the Battery

The battery must be removed from the machine so it
can be filled with electrolyte and charged. Remove
the battery and activate it as follows:
Removing the Battery
1. Tip seat forward exposing battery.
2. Remove wing nut securing battery hold downs to
rider chassis (Fig. 4).
14
3
1
4
8
2
9
10
7. Wire tie
8. Spacers (metal)
9. Washer, 5/16" I.D.
10. Screw, 5/16–18 x 1 1/2"
(38 mm)
3
Figure 4
1. Wing nut
2. Battery hold–down
3. Lift up on top battery hold down and pivot
rearward
4. Remove battery from chassis and set it aside.
Adding Electrolyte
1. Remove filler caps from battery and slowly fill
each cell until electrolyte is just above the
"LOWER" fill line.
2. Leave filler caps off and connect a 3-4 amp
battery charger to battery posts. Charge battery at
a rate of 4 amperes or less for 4 hours (12 volt).
POTENTIAL HAZARD
Charging battery produces gasses.
WHAT CAN HAPPEN
Battery gasses can explode.
HOW TO AVOID THE HAZARD
Keep cigarettes, sparks and flames away
from battery.
3. When battery is charged, disconnect charger
from electrical outlet and battery posts.
1
2
3. Filler cap