Specifications; Attachments/Accessories; Operation; Checking The Engine-Oil Level - Toro 23515 Operator's Manual

Note: Raising the tines may require significant effort if you
added extra optional weights to the machine.
Note: Make sure that the transport-lock pin is engaged when
transporting the machine (see
1. Tine-control lever—raised
position

Specifications

Length
Width
Height
Weight (as shipped with 2
weights)

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
Figure 4).
g013076
Figure 6
2. Tine-control
lever—lowered position
150 cm (59 inches)
79 cm (31 inches)
127 cm (50 inches)
172.4 kg (380 lb)

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
The engine crankcase can hold 0.55 L (20 oz) of oil. Use
1
only high-quality SAE 10W-30 weight detergent oil that has
the American Petroleum Institute (API) service classification
SH, SJ, Sl or higher.
Note: When the crankcase is empty, pour about 3/4 of the
crankcase capacity of oil in the crankcase, then follow the
2
procedure in this section.
1. Move the machine to a level surface.
2. Clean around the dipstick
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
4. Wipe the dipstick clean with a clean cloth.
5. Insert the dipstick into the filler neck, but do not
rotate the cap , then remove it.
6. Read the oil level on the dipstick.
7. If the oil level reading is below the lower limit mark on
the dipstick, remove the dipstick and slowly pour only
enough oil into the filler hole to raise the oil level to
the upper limit mark on the dipstick.
Important: Do not overfill the crankcase with oil
and run the engine; engine damage will result.
Drain the excess oil until the oil level reaches the
upper limit mark on the dipstick.
8. Insert the dipstick into the filler neck and rotate the cap
clockwise until it is tight.
10
(Figure 7).
g017580
Figure 7