Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the rst 8 operating
hours
After the rst 50
operating hours
After the rst 200
operating hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 400 hours
Every 800 hours
Yearly
Every 2 years
Maintenance Procedure
• Check the torque of the wheel nuts or bolts (after the rst 1–4 hours of
operation and then after 10 hours of operation).
• Change the engine oil and oil lter.
• Change the planetary gear drive oil.
• Change the planetary gear drive oil.
• Change the rear axle lubricant.
• Check the engine oil level.
• Check and clean the cooling system.
• Check the hydraulic uid level.
• Check the tire pressure.
• Check the reel to bedknife contact.
• Check the interlock switches.
• Drain the fuel lter/water separator.
• Remove debris from the rear screen, oil cooler, and radiator (more
frequently in dirty conditions).
• Inspect the hydraulic lines and hoses for leaks, kinked lines, loose
mounting supports, wear, loose ttings, weather deterioration, and
chemical deterioration.
• Grease the bearings and bushings.
• Check the condition of the battery.
• Inspect and tighten the cooling system hoses and connections.
• Check the condition and tension of the alternator belt.
• Change the engine oil and oil lter.
• Check the torque of the wheel nuts or bolts.
• Service the air cleaner. (Service the air cleaner earlier if the air cleaner
indicator shows red. Service it more frequently in extremely dirty or dusty
conditions.)
• Check the fuel lines and connections.
• Replace the fuel lter canister.
• Replace the fuel pre-lter.
• Check the rear axle lubricant level.
• Change the planetary gear drive oil.
• Change the planetary gear drive oil.
• Change the rear axle lubricant.
• Check the rear wheel toe-in.
• Change the hydraulic uid.
• Change the planetary gear drive oil.
• Drain and clean the fuel tank.
• Drain and ush the cooling system.
• Replace all moving hoses.
• Drain/ush the hydraulic tank.
31