Setup; Greasing The Machine; Replacing The Warning Decal; Reading The Manuals And Viewing The Training Materials - Toro 30412 Groundsmaster 4000-D Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Greasing the Machine

No Parts Required
Procedure
Before the machine is operated, it must be greased
to ensure proper lubricating characteristics; refer to
Greasing the Bearings and Bushings procedure of
Lubrication , page 33. Failure to properly grease the
machine will result in premature failure of critical parts.
2

Replacing the Warning Decal

Parts needed for this procedure:
1 Warning Decal
Procedure
On machines requiring European CE compliance,
replace the warning decal, part no. 114–5605 with the
warning decal part no. 114–5604.
Description
No parts required
Warning Decal
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Materials
Pre-delivery Inspection Sheet
Declaration of conformity
Qty.
–
Grease the machine.
Used only on machines requiring
1
European CE compliance.
1
1
Read the manuals and view the
1
training materials before operating the
machine. Use the remaining parts for
1
the installation of attachments.
1
1
3
Reading the Manuals and
Viewing the Training Materials
Parts needed for this procedure:
1 Operator's Manual
1 Engine Operator's Manual
1 Parts Catalog
1 Operator Training Materials
1 Pre-delivery Inspection Sheet
1 Declaration of conformity
Procedure
1. Read the manuals.
2. View the Operator Training materials.
14
Use