General Operation - AEG BSS 4804 Instruction Manual

8 RAN button (random playback)
9 MUTE button
10 EQ button (Equalizer)
11 button (On/Off)
First Use of the Device/Introduction
NOTE:
The device is operated primarily with the remote control.
Thus the descriptions refer to the buttons on the remote
control. Some buttons are also on the device. Buttons with
the same name have the same function.
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Power supply
• Insert the grid plug into a properly installed three prong
socket.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Insert/Replace Battery in Remote Control
• Open the battery compartment on the underside of the
remote.
• Insert AAA/R03 1.5 V type batteries. Pay attention to the
correct polarity (see bottom of battery compartment)!
• Close the battery compartment.
If the remote is not in use for a lengthy period of time, please
remove the battery to prevent the battery acid from "leaking".
WARNING:
• Do not expose the batteries to intense heat, such as
sunlight, fire or similar. Danger of explosion!
• Keep batteries out of the reach of children. They are
not toys.
• Do not force batteries open.
• Avoid contact with metallic objects. (Rings, nails, screws
etc.) Danger of short circuits!
• Short circuits may overheat or even ignite batteries.
This may lead to combustion.
• When transporting the batteries, cover the terminals for
your safety with an adhesive strip.
• If a battery leaks, do not rub the fluid into the eyes or
the skin. If acid comes into contact with the eyes, rinse
with purified water and seek medical advice if symp-
toms persist.
CAUTION:
• Different battery types or new and used batteries may
not be used together.
• Batteries must not be disposed of in the garbage.
Please bring used batteries to competent collection
centers or back to the dealer.

General Operation

Switch device on/off
• With the button (11/3), you can switch the unit between
standby and operating mode. In standby, the pilot lamp
(5 on the device) lights red.
• To disconnect the unit completely from the mains, pull
the mains plug from the socket.
NOTE:
After about 60 minutes without signal, the device will auto-
matically switch to Standby.
Volume
By pressing the VOL+/VOL- buttons (6) you can adjust the
desired volume.
NOTE:
Keep the >/< buttons (4) pressed on the device to set the
device to the desired volume.
Infrared Remote Control
For wireless control within a distance of 5 m. If the distance
decreases you should change the batteries. For proper
operation mind a clear view between the remote control and
the sensor on the device.
Sound Settings
(Preset equalizer function). Different sound modes are
available. Press the EQ button (10) repeatedly, to select the
individual sound modes. Select the sound mode that you like
best by listening to it.
NOTE:
If necessary, change the EQ setting in your playback unit to
create the best sound.
MUTE (9)
For immediate muting of the volume. Press MUTE again to
cancel the function.
NOTE:
If the function has been activated, the indicator light (5) will
flash slowly.
English
31