Fill Crankcase With Oil - Toro 71197 WHEEL HORSE Setup Instructions

POTENTIAL HAZARD
Charging battery produces gasses.
WHAT CAN HAPPEN
Battery gasses can explode.
HOW TO AVOID THE HAZARD
Keep cigarettes, sparks and flames away
from battery.
4. When the battery is fully charged, disconnect the
charger from the electrical outlet and from the
negative and positive battery posts (Fig. 6).
5. Slowly pour electrolyte into each cell until the
level is once again up to the "UPPER" line on
the battery case (Fig. 5).
6. Install the battery and battery box in the tractor:
refer to the Operator's Manual, Installing the
Battery.

Fill Crankcase with Oil

The tractor is shipped from the factory without oil in
the engine crankcase: refer to the Operator's Manual,
Engine Oil Specifications for oil type, viscosity, and
crankcase capacity. Only add about 80% of the
specified amount of oil. Then check the oil level and
add only enough oil to raise the level to the "FULL"
mark on the dipstick.
Lubricate the Tractor
Refer to the Operator's Manual, Greasing and
Lubrication.
Insert Keys into Ignition and
"Key Choice" Switches
The "Key Choice" switch is located on the seat
bracket in front of and below the seat. Refer to
Operator's Manual, Operation Section.
Check Safety System
Refer to the Operator's Manual, Checking Safety
System.
Set-Up Instructions
5