Table of Contents
Advertisement
PowerShift operation
Belt routing
Assembly
Note:
Determine left and right sides of the
snowthrower by standing in the normal
operator's position behind the handles.
Install Wheels (Fig. 2)
1.
Carefully turn machine onto its left side. Place a
wood block under the left axle end.
2.
Slide the short spacer and a wheel onto the right
axle end. The side of the wheel with six spokes
must face the center of the machine.
3.
Slide a pushnut onto the end of the axle.
4.
Using a hammer, strike the pushnut to seat the
nut FIRMLY in place.
5.
Turn the machine over on its right side so that
the left axle end is pointing up.
6.
For the left side, slide the long spacer and a
wheel onto the left axle end. The side of the
wheel with six spokes must face the center of the
axle.
7.
Place a wood block under the right axle end.
Repeat steps 3 and 4.
8
Install Discharge Chute And
Chute Handle (Fig. 3)
Models 38412 & 38418
1.
Place chute handle over chute ring.
2.
Insert discharge chute between chute ring and
chute handle. Align holes.
3.
Secure back of chute and handle to center hole in
chute ring with a carriage bolt and lock nut.
Position nut on outside of chute.
Note:
Chute ring may be rotated to ease
assembly of discharge chute.
4.
Secure chute and handle to remaining holes in
chute ring and tighten all nuts SECURELY.
Install Chute Crank (Fig. 4)
Models 38433 & 38438
1.
Insert flattened end of chute crank through hole
in shroud while aligning mounting bracket with
holes in lower handle. Slowly rotate crank until
flattened end fits into hidden gear opening and
chute ring turns with crank. Make sure plastic
bushing is fully inserted into hole in mounting
bracket, then secure mounting bracket to handle
with (2) capscrews and locknuts.
Hide quick links:
Advertisement
Table of Contents
