Installations; Earthing Instructions - LG MP-9483SLA Service Manual

BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
INSTALLING
1. Empty the oven and clean inside it with a soft,
damp cloth. Check for damage such as misaligned
door, damage around the door or dents inside the
cavity or on the exterior.
2. Put the oven on a counter, table, or shelf that is
strong enough to hold the oven and the food and
utensils you put in it. (Use care when handling.)
3. Do not block the vent and the air intake openings.
Blocking vent or air intake openings can cause
damage to the oven and poor cooking results.
Make sure the microwave oven legs are in place to
ensure proper air flow.
4. The oven should not be installed in any area where
heat and steam are generated, because they may
damage the electronic or mechanical parts of the
unit.
Do not install the oven next to a conventional
surface unit or above a conventional wall oven.
5. Use the oven in an ambient temperature less than
104 °F(40 °C).
6. Place the oven on a sturdy and flat surface at least
10 cm(4 inches) from the wall.
7. Place the oven as far away as possible from TV,
RADIO, COMPUTER, etc., to prevent interference.
8. Do not touch the front glass during or after cooking
of the Grill and convection and Combination mode.
This glass is very hot during heater operating.
9. Do not operate the oven at microwave and
combination mode with Grill rack placed in the
cavity when the oven is empty.
Downloaded from www.Manualslib.com

INSTALLATIONS

10cm
manuals search engine

EARTHING INSTRUCTIONS

This oven is designed to be used in a fully earthed
condition.
It is imperative, therefore, to make sure it is properly
earthed before servicing
WARNING-
THIS APPLIANCE
MUST BE EARTHED
IMPORTANT
The wires in this mains lead are colored in
accordance with the following code:
Green-and-yellow:
Blue:
Brown:
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows.
The wire which is colored green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol (
colored green or green-and-yellow.
The wire which is colored blue must be connected to
the terminal in the plug which is marked with the letter
N or colored black.
The wire which is colored brown must be connected
to the terminal in the plug which is marked with the
letter L or colored red.
3-1
Earth
Neutral
Live
) or