LG MP-9483SLA Service Manual page 15

H. FAN MOTOR ASSEMBLY / REMOVAL
1) Remove controller assembly, air-guide, power cord,
latch board-R from upper.
2) Disconnect the leadwire from fan motor, latch board-R
and Noise filter.
3) Remove the three screws holding the the upper plate
to the oven cavity.
4) Remove the fan motor ASS'Y to the upper plate.
I. HIGH VOLTAGE CAPACITOR, H.V. FUSE
TRANSFORMER AND DIODE REMOVAL
1) Discharge the high voltage capacitor.
2) Disconnect the leadwire from H.V. transformer, MGT,
H.V. Fuse and H.V. capacitor.
3) Remove the screw holding the H.V. transformer and
remove the high voltage diode earth screw.
BKT H.V.C
H.V. Diode
Downloaded from www.Manualslib.com
H.V.
Transformer
H.V. Fuse
Fan Motoer Assembly
H.V.
Capacitor
manuals search engine
J. REMOVING THE TURNTABLE MOTOR
1) Remove the metal tray.
2) Remove the turntable shaft VERY CAREFULLY.
3) Lay the unit down on its back.
4) Remove the turntable motor cover.
The turntable base cover is easily removed by
pinching the six parts with a wire cutting.
5) Disconnect the leadwire from the turntable motor
terminals.
6) Remove the screw securing the turntable motor to
the oven cavity Ass'y.
7) After repairing the motor, rotate the removed
turntable motor cover.
8) Fit the turntable motor cover's projecting part to the
base plate slit and fasten a screw.
9) The taptite screw shall be used when a turntable
motor cover is secured with a screw.
NOTE:
1. Remove the wire lead from the turntable motor
VERY CAREFULLY.
2. Be sure to grasp the connector, not the wires, when
removing.
Taptite Screw
Turntable Motor
5-5
Wire Leads