Getting Started - D-Link DES-1100-10P Manual

Getting Started

Power on the Switch:

Power on the Switch before plug in any Ethernet cable, system will go through
Power-On-Self-Test (POST) with LEDs lighting in Green or Amber. Then, after
completing the POST, LEDs will stay at the state as the table below..
LED Indication
Power
PoE Power Budget
System
Log into the Switch:

Connect PC to any port of the Switch via Ethernet cable. Make sure the LAN
setting of PC
is set to work in the same subnet as Switch device which the default IP address is
10.90.90.90.
Type IP address 10.90.90.90 in the WEB Browser of PC, you will then be asked to
enter ID and Password so that you can log into the Switch device.
The default ID is "admin".
The default Password is "admin".
Press "OK", you will log in and see the welcome page for "Home".
Fig. Front panel of DES-1100-10P
Color /
State
Green On
Full Green On
75% Green On
50% Green On
25% Green On
Amber On
D-Link Web Smart Switch User Manual
Description
The device is powered on.
Power for POE is full, not been consumed yet.
Device passed POST and ready for login.
3