Editing Transponder / Channels - Ten-Haaft CARO Digital MA Operating Instructions Manual

Editing transponders / channels
Confi guration only with competence
The program menu (press MENU once) contains the two sub-menus „Edit
Transponder" and „Edit Channel". These two sub-menus allow you to view and
edit the settings required for the reception of the individual channels. Wrong
E
entries at the individual positions may prevent the reception of one or more
channels.
The program menu (press MENU once) contains the two sub-menus „Edit Trans-
ponder" and „Edit Channel". These two sub-menus allow you to view and edit the
settings required for the reception of the individual channels. Wrong entries at the
individual positions may prevent the reception of one or more channels.
The automatic search function usually provides the correct settings automatically.
Under certain conditions, you may input settings received e.g. from your broadcas-
ting station to enable the reception of specifi c programs.
When the decoding function of the digital CI receiver is used, encrypted programs
can only be decoded if the correct data is entered in the menu „Edit Transponder"
under „Network ID" and „T.Stream ID". These settings must be checked and adjusted,
if required, when the satellite's channel allocation is changed by the operators.
If an encrypted channel for which you have a valid smartcard cannot be decoded,
select „Edit Transponder" and highlight „Network ID". Press LIST. Changed settings
are now automatically corrected. In this case, the entry will change to green. Press
EXIT and confi rm the confi rmation prompt with OK. Your channel list is now up to
date and the encrypted program can be received.
84