Setting Default Line To Desk Phone Or Pc; Toggling On/Off Over-The-Air Subscription; Setting The Range; Ending Subscription - Plantronics SAVI OFFICE WO100 User Manual

Setting Default Line to Desk Phone or PC

The Savi Office system ships with the desk phone as the default
outbound line. This means any call initiated from the headset
with the call control button will open desk phone audio. You can
change your default outbound line from the base talk buttons.
While the system is in idle mode, press and hold the PC talk
button or the desk phone talk button for three seconds to
select that device as your default outbound line. The talk button
indicator light will flash green for four seconds confirming the new
setting.
PC Talk Button
Indicator Light

Toggling On/Off Over-the-Air Subscription

The Savi Office system ships with the over-the-air subscription
enabled. You can toggle on or off over-the-air subscription using
the subscription button on the base. With the master headset
and the system idle, press the subscription button for
UNDOCKED
three seconds. The subscription button will flash green for four
seconds if over-the-air subscription is on and red for four seconds
if off.

Setting the Range

With the master headset
DOCKED
subscription button for three seconds. Both the desk phone and
the PC talk buttons will flash green for high range. If you press
the subscription button again for three seconds, the talk buttons
will flash yellow for medium range. If you press the subscription
button again for three seconds, the talk buttons will flash red for
low range.

Ending Subscription

If the base is in subscription mode (secure or over-the-air), and
you want to end the base from searching for a headset, press the
subscription button again. The subscription light will turn solid red
for four seconds and then go to it's previous state.
Plantronics Savi User Guide
Desk Phone
Talk Button
Indicator Light
and the system idle, press the

Placing the Headset in Sleep Mode

If you won't be using the headset for a long duration and the
headset will not be in the charge cradle, you can put the headset
in sleep mode by pressing the call control button for three
seconds while in an idle state. To exit sleep mode, press the
headset call control button again for three seconds.

Subscription Button Indicator Light

Master headset subscribed to base
Base in master subscribing mode
Base conferencing in additional guest
headset(s)
headsets subscribed to base
Desk Phone and PC Talk Buttons
Indicator Lights
No active audio link
Incoming call
Master headset muted
Call on-hold
*When bringing up a link from the base, the talk button will be
solid yellow until a link is established. This could take up to several
seconds especially for wideband audio and/or when in moderate
to high density environments. If you press the talk button when
the indicator light is yellow, it will terminate the search for an audio
link.
Solid green
Flashes red and green
Flashes yellow and
green
Solid yellow
Off
Flashes green
Solid green
Solid red
Flashes red
Solid yellow
16