Opening The Door; Changing A Program - Electrolux EWF10744 User Manual

16 www.electrolux.com
Step 4
NOTE
After starting the washing program the dot ( ) on the display starts
to flash. The appliance will automatically adjust the selected
program duration according to the type and size of the load
( approximately 15 minutes ) . When this phase ends the dot ( ) lights
up fixed and t he display will show adjusted program duration.
5.2 Interruption Of A Program
To pause press Start/Pause. The
indicator will start flashing.
Press the Start/Pause again. The
program will continue.

5.3 Changing A Program

Changing a running program is possible
only by switching off the appliance.
Press the "On/Off" button to cancel the
program and to turn off the appliance.
Press the "On/Off" button again to
start the appliance. Now, you can set a
new washing program.
The appliance will not drain the
water.
5.4 Changing The Options
It is possible to change only some
option after the program has
started.
1. Press the touchpad Start/Pause. The
indicator will start flashing.
2. Change the options.
3. Press Start/Pause again. The program
will continue.
- Starting a program
To start a program, press the Start/Pause (
corresponding pilot light will stop flashing and a default program
duration will be displayed on the screen.

5.5 Opening The Door

While a program or the Delay End
is operating, the appliance door is
locked and the door lock indicator
" " is on.
First set the machine to PAUSE by
pressing the "Start/Pause"
touchpad. Wait until the door lock
indicator " " goes off, then the
door can be opened.
If the door lock indicator "
does not disappear, this means
that the machine is already
heating and the water level is
above the bottom edge of the
door or the drum is turning. In
this case the door CAN NOT be
opened. If you need to open it, you
must drain the water to open the
door.
To drain the water, you have to
switch the machine off by pressing
the "On/Off" button to deactivate
the appliance. Turn On the
machine and select "Drain & Spin"
option, then press Start/Pause
touchpad to start the program.
You can select "No Spin
", if you want the machine
to only drain the water.
) touchpad, the
"