o Set the month
o Set the time
Place the user selection switch to User A.
Follow the instructions in the manual pages 26 ‐ 29 on applying the arm cuff
Take a measurement with your blood pressure monitor
o Press the Start/Stop button.
o The arm cuff will start to inflate automatically taking a measurement.
o When the measurement is complete, blood pressure and pulse rate are displayed.
Step 2: Get ready to use your blood pressure monitor with HealthVault™
If HealthVault Connection Center is not running on your computer, please start it and sign in to
your account. Connection Center then will open to a screen showing your device(s).
Select the Omron Blood Pressure device picture on the left hand side of Connection Center.
If you do not see a picture of your device in Connection Center, select Set up a new device and
follow the on‐screen instructions.
Step 3: Connect your Omron 10 Series +™ Blood Pressure Monitor to
your computer and upload your reading to HealthVault™
Press the Start/Stop button to turn the monitor off.
Find the USB cable that came with your blood pressure monitor.
Plug the small end of your USB cable into the slot on your blood pressure monitor that's marked
with the USB symbol.
Plug the large end of your USB cable into your computer.
□
The symbol "
connected to the computer. After several seconds the blood pressure display will be blank.
NOTE: If the USB cable was connected when you took the last measurement, please disconnect and
connect the cable again. Also, do not unplug the USB connector until the data has finished uploading.
If the month is not correct:
•
press the up button
•
press the down button
Once the month is correct, press the set button again
If the time is not correct:
•
press the up button
•
press the down button
Once the time is correct, press the Start/Stop button
" will start circling on the blood pressure monitor display when it is successfully
to increase the month
to decrease the month
to increase the hours and minutes
to decrease the hours and minutes
2