High powered 300 mbps access point for the 2.4 ghz wifi band for outdoor service, poe powered with mĂșltiple physical and virtual interfaces that supports vlan and has an eirp of 27dbm(0.5w). (7 pages)
123 manual, turbo ofdm compact outdoor radio with throughput booster, installation in point to point, point to multipoint mode with firmware v2.0.3b2p1 (23 pages)
Page 1
Wireless - Equipment 123 Manual LP-C290N 300 Mbps Wi-Fi Access Point (AP). Configuration as a Universal Repeater LPC290N_M123_END01W 123 Manual LP-C290N 300 Mbps Wi-Fi Access Point (AP). Configuration as a Universal Repeater Please check the package contents, it must contain the components shown in figure 1 a.
300 Mbps Wi-Fi Access Point (AP) - Configuration as a Universal Repeater This manual explains the configuration steps for Client Mode, (inside the blue frame). It is tied to an LP-C290N working as an AP connected to an ADSL Modem. For other operation modes, please consult the other 1 2 3 Manuals available for download at www.lanpro.com.
300 Mbps Wi-Fi Access Point (AP) - Configuration as a Universal Repeater You must decide how to power the el LP-C290N, be it from the AC Mains with the furnished power adaptor or through the Ethernet cable by using a PoE PSD device.
Page 4
Proceed to select OK twice as shown in figure 9. Figure 9 Proceed to open your preferred browser and with the LP-C290N IP address. In this case, use the default address 192.168.1.1, as shown in Figure 10. Figure 10...
Figure 11 Proceed to validate the administration IP of your LP-C290N in your diagram, remember that in this case the LP-C290N is a client of a network, and a router or ADSL modem should be there, responsible for delivering IP addresses to the connecting Clients.
Page 6
Proceed to open your preferred browser and input the new address 192.168.1.2, as shown in Figure 13 Figure 13 The LP-C290N, will prompt for your credentials for accessing your configuration, in this case use the default ones: User name: admin y...
Wireless - Equipment - 123 Manual - LP-C290N 300 Mbps Wi-Fi Access Point (AP) - Configuration as a Universal Repeater The equipment will show the counter while the reset takes place as shown in figure 16. Figure 16 Proceed to select the network to connect to, in this example LanPro LP-C290N.
Management/ Language(Time) and input it in the Password field and immediately select Apply, as shown in figure 20. Figure 20 LanPro is continuously improving its products and reserves the right to change specifications and availability without prior notice. www.lanpro.com...