Table of Contents
Advertisement
Quick Links
Installation Point-to-Point, Multipoint
Check the box contentment.
1
Screw the antenna as you can see in figure 2; in case of having an antenna with pigtail
2
type cable, make sure that antenna cable is plugged into the antenna and then screw the
other end into your SMA connector of your LP-1522. See figure 3. Note: Never operate
the LP-1522 without the antenna, because you will damage the Rf output stage.
figure 2
Connect your PC or Switch to the LAN port of
3
your LP-1522, as it is shown in Figure 4.
Connect the DC electrical power plug into the power jack, see figure 5. The
4
LP-1522 can be fed alternatively through a LAN port simultaneously with DATA.
For this, you must use a LP-PoE150(*) injector on the side of your Switch or
PC and send Data+Power to the LP-1522 up to 100m distance with our new
LP-cE Cat5e or LP-c6 Cat6 copper UTP cables and 80m distance with LanPro
LP-BMcAt5E bi-metallic UTP Cable, see figure 6.
(*) the LP-PoE150 Injector is not included.
figure 5
123 MANUAL INItIAL coNfIgURAtIoN
Access Point and 800mW Router,
with the standard 802.11b/g,
and with PoE technology and external antenna
1
LP1522_M123_ENB01W
LP-1522
figure 1
figure 3
figure 4
figure 6
(*) the
LP-PoE150
Injector
is not
included.
www.lanpro.com
Advertisement
Table of Contents
Related Manuals for Lanpro LP-1522
Summary of Contents for Lanpro LP-1522
- Page 1 SMA connector of your LP-1522. See figure 3. Note: Never operate the LP-1522 without the antenna, because you will damage the Rf output stage.
- Page 2 For this configuration you will need MAC addresses of the equipment that will be part of the Point-to-Point and Multipoint link connection(s). Open your selected browser and input the same default address: 192.168.1.254, as you can see in Figure 7. figure 7 In figure 8, select: Operation Mode.
- Page 3 Once you see the window shown in Figure 12, indicating “Change setting successfully!” click: then: oK, and the equipment will restart. figure 12 Now proceed to set WDS security, for this, in the windows shown in Figure 13, select: Wireless, WDS Settings, Set Security.
- Page 4 Changes. In other to access to your equipment again, you must input these data once you are asked. figure 17 In our Website www.lanpro.com you may be able to see 123 Manuals to configure you equipment like AP, Point-to-Point, Multipoint, Client and WISP.
Need help?
Do you have a question about the LP-1522 and is the answer not in the manual?
Questions and answers