Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ResMed RPS II
Summary of Contents for ResMed RPS II
- Page 1 User guide English...
-
Page 2: Power Station
U.S. • To recharge the ResMed Power Station II using an Air 10 power supply unit (supplied with Air 10 devices) or the Air 10 DC converter, an Air 10 power supply unit adaptor is required (part no. 37342). -
Page 3: Intended Use
6. DC output cable Air 10 Power supply unit adaptor Note: To recharge the RPS II using an Air 10 power supply unit (supplied with Air 10 devices) or the Air 10 DC converter, an Air 10 power supply unit adaptor is required (part no. - Page 4 CAUTION • Ensure the RPS II and the device are turned off before setting up. • When the RPS II is plugged to the mains power supply, ensure all cables are properly connected. Charging the battery Refer to illustration C.
- Page 5 Indicators Refer to illustration B. The RPS II provides LEDs to indicate its current operating state. LED indicator Status Battery charge level (B-6) One amber flashing (audible alert Less than 5% beeps continuously) One green flashing (audible alert Less than 10%...
-
Page 6: Cleaning And Maintenance
Cleaning and maintenance WARNING Do not immerse the RPS II in water, and do not use liquids to clean any part of the product. Disconnect the battery from the power supply unit and the device. Remove all cables. -
Page 7: Troubleshooting
Press the audible alert mute button to mute the than 5%. alert. Recharge the battery as soon as possible. RPS II sounds an audible alert for 10 seconds and a green LED is flashing The battery charge level is below Recharge the battery as soon as possible. -
Page 8: Technical Specifications
(EMC) according to IEC60601- 1-2, for residential, commercial, and light industry environments. Information regarding the electromagnetic emissions and immunity of these ResMed devices can be found on www.resmed.com, on the Products page under Service and Support. Click on the PDF file for your language. -
Page 9: General Warnings And Cautions
• As the battery ages, the available capacity decreases. When the remaining battery capacity is getting low, do not rely on the RPS II as the primary supply. • Ensure the internal battery of any connected device is kept charged up to provide backup power in the event of loss of power from RPS II. - Page 10 If there are any defects, the system should not be used. • The RPS II is to be used only in accordance with the intended use stated in this guide. Damage to equipment or injury can result from modifications to the equipment or operation.
-
Page 11: Limited Warranty
• Portable diagnostic/screening devices This warranty is only available to the initial consumer. It is not transferable. If the product fails under conditions of normal use, ResMed will repair or replace, at its option, the defective product or any of its components. - Page 13 See www.resmed.com for other ResMed locations worldwide. For patent and other intellectual property information, see www.resmed.com/ip. AirSense, AirCurve, H5i, S9, Stellar and VPAP are trademarks and/or registered trademarks of the ResMed family of companies. VSIII is a trademark of ResMed Paris SAS. Velcro is a registered trademark of Velcro Industries B.V.
Need help?
Do you have a question about the RPS II and is the answer not in the manual?
Questions and answers