Positioning The Seat; Adjusting The Motion Control Levers; Pushing The Machine By Hand - Toro Z14-38 TimeCutter Z 74402 Operator's Manual

Positioning the Seat

The seat can move forward and backward. Position the seat
where you have the best control of the machine and are
most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Fig. 12).
2. Move the seat to the desired position and tighten the
knobs.
1
Figure 12
1. Adjustment knobs
Adjusting the Motion Control
Levers
The motion control levers can be adjusted higher or lower
for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Fig. 13).
2. Move the control lever to the next set of holes. Secure
the lever with the 2 bolts (Fig. 13).
3. Repeat the adjustment for the opposite control lever.
1
1. Control lever
2. Bolt

Pushing the Machine by Hand

Important
Always push the machine by hand. Never
m–6433
tow the machine because damage may occur.
To Push the Machine
1. Park the machine on a level surface and disengage the
blade control (PTO).
2. Move the motion control levers to the brake position,
stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Push each bypass lever forward and then push them out
(Fig. 14).
4. Move the motion control levers to the center, unlocked
position to disengage the brake (Fig. 9).
5. Push the machine.
17
2
3
Figure 13
3. Control arm shaft
m–6417