Assembling And Unfolding The Handle - Toro 20794 Operator's Manual

114-7982
1. Warning—read the
Operator's Manual.
2. Thrown object
hazard—keep bystanders
a safe distance from the
machine.
3. Cutting/dismemberment
hazard of hand or foot,
mower blade—remove
the ignition key and read
the instructions before
servicing or performing
maintenance.
115-8411
1. Unlocked
4. Cutting/dismemberment
hazard of hand or foot,
mower blade—stay away
from moving parts.
5. Cutting/dismemberment
hazard of hand or foot,
mower blade—do not
operate up and down
slopes; operate side to
side on slopes; stop the
engine before leaving the
operating position; and
look behind you when
backing up.
2. Locked
Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• Ensure that the cables are routed to the outside
of the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the mower housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height in the Operation section.
2. Attach the handle ends to the mower housing with
2 washers and 2 handle bolts (Figure 3), but do not
tighten the handle bolts.
1. Washer
2. Handle bolt
5
Figure 3
3. Handle end