Stopping The Machine; Adjusting The Height-Of-Cut; Using The Lift Assist Pedal - Toro 74408 Z334 Z Master Operator's Manual

To turn, release pressure on the motion control lever
toward the direction you want to turn (Figure 14).
To stop, push the motion control levers to the
neutral position.

Stopping the Machine

To stop the machine, move the traction control levers
to the center position and move them out to the locked
position, disengage the power take off (PTO), and turn
the ignition key to off.
Set the parking brake when you leave the machine; refer
to Setting the Parking Brake in Operation , page 11.
Remember to remove the key from the ignition switch.
Children or bystanders may be injured if they
move or attempt to operate the tractor while it
is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.

Adjusting the Height-of-Cut

The height-of-cut is adjusted from 1 to 5 inch
(25 to 127 mm) in 1/4 inch (6 mm) increments by
relocating the clevis pin into different hole locations.
1. Raise the height-of-cut lever to the transport
position (also the 5 inch (127 mm) cutting height
position) (Figure 15).
2. To adjust, remove the clevis pin from the
height-of-cut bracket (Figure 15).
3. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired and,
insert the clevis pin (Figure 15).
4. Move the lever to the selected height.
1. Height of cut holes

Using the Lift Assist Pedal

The lift assist pedal is used for raising the mower deck.
This allows for easier raising of the mower deck.
1. Place your foot onto lift assist lever.
2. Press on the lift assist lever while pulling up on the
height-of-cut lever (Figure 16).
1. Lift Assist pedal
17
Figure 15
2. Clevis Pin
Figure 16
2. Height-of-cut lever