Adjusting The Tracking - Toro 74408 Z334 Z Master Operator's Manual

Figure 47
5. If the ends of the levers hit against each other, adjust
the levers by rotating them out to the neutral locked
position and carefully bend them outward. Repeat
this step as needed.

Adjusting the Tracking

1. If the machine turns right or left when the handles
are pushed forward together, adjust the stop on the
side opposite that the machine turns.
2. Loosen the bolt located in front of the control lever.
3. Move the stop until the machine drives straight
(Figure 48).
4. Tighten the bolt located in front of the control lever
(Figure 48).
1. Control lever
2. Stop
37
Figure 48
3. Bolt in front of the control
lever