Servicing The Spark Plugs - Toro 30518 Operator's Manual

Figure 31
1. Oil filter
3. Apply a thin coat of new oil to the rubber gasket on the
replacement filter (Fig. 31).
4. Install the replacement oil filter to the filter adapter,
turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 3/4 turn (Fig. 31).
5. Fill the crankcase with the proper type of new oil; refer
to Servicing the Engine Oil, page 28.

Servicing the Spark Plugs

Service Interval/Specification
Check the spark plugs after every 100 operating hours.
Ensure that the air gap between the center and side
electrodes is correct before installing the spark plug. Use a
spark plug wrench for removing and installing the spark
plugs and a gapping tool/feeler gauge to check and adjust
the air gap. Install a new spark plugs if necessary.
®
Type: Champion RCJ-8Y or equivalent
Air Gap: 0.030 inch (0.75 mm)
Removing the Spark Plug
1. Disengage the PTO, turn the ignition key to off, and
remove the key.
2. Wait for all moving parts to stop before leaving the
operating position and then chock or block tires.
3. Disconnect the wires from the spark plugs (Fig. 32).
2
1
m–7451
2. Adapter
s
30
1
Figure 32
1. Spark-plug (2)
4. Clean around the spark plugs to prevent dirt from
falling into the engine and potentially causing damage.
5. Remove the spark plugs and the metal washers.
Checking the Spark Plugs
1. Look at the center of the spark plugs (Fig. 33). If you
see light brown or gray on the insulator, the engine is
operating properly. A black coating on the insulator
usually means that the air cleaner is dirty.
2
1
Figure 33
1. Center electrode insulator
2. Side electrode
Important
Never clean the spark plugs. Always replace
the spark plugs when it has a black coating, worn
electrodes, an oily film, or cracks.
2. Check the gap between the center and side electrodes
(Fig. 33). Bend the side electrode (Fig. 33) if the gap is
not correct.
Installing the Spark Plug
1. Install the spark plugs and the metal washer. Ensure that
the air gap is set correctly.
m–7453
3
0.030 inch
(0.75 mm)
3. Air gap (not to scale)
s