Toro 30518 Operator's Manual page 23

Adjusting the Caster Position
1. Using the Height-of-Cut Chart (on page ), adjust the
caster spacers to match with the axle hole selected
(Fig. 21).
2
Figure 21
1. Clevis pin
2. Spacer, 3/16 inch (5 mm)
2. Remove the clevis pin, slide the caster from the support,
and change the spacers (Fig. 21).
3. Install the caster in the support and insert the clevis pin
(Fig. 21).
1
3
m–3791
3. Spacer, 1/2 inch (13 mm)
23