Unpacking The Lawn Mower; Installing The Handle; Loose Parts - Toro 20833 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1.
2.
3.
4.
5.
6.
Note: Determine the left and right sides of the machine from the normal operating position.

1. Unpacking the Lawn Mower

Procedure
1. Carefully remove the lawn mower from the box.
Folding or unfolding the handle improperly can
pinch, stretch, or damage one or more of the
cables. Any pinched, stretched, or damaged
cable may cause an operational failure that
results in an unsafe operating condition.
• Do not pinch, stretch, or damage the cables.
• Handle the cables with care when folding or
unfolding the handle.
• Do not use the lawn mower if one or more
of the cables are pinched, stretched, or
damaged. Contact an Authorized Service
Dealer.
2. Lay the upper handle on the ground behind the lawn
mower with the handle label facing up.
Description
No parts required
No parts required
No parts required
No parts required
No parts required
No parts required
Qty.
–
Unpack the lawn mower.
–
Install the handle.
–
Install the starter rope.
–
Adjust the handle height.
–
Assemble the grass bag.
–
Fill the engine with oil.

2. Installing the Handle

Procedure
1. Loosen the handle height adjustment knobs and
rotate the lower handle toward the rear of the lawn
mower until it seats into one of the handle height
settings as shown in Figure 3. To set the handle
height, refer to Adjusting the Handle Height.
1. Handle knob
2. Upper handle section
3. Oval-head bolt
2. Remove the handle knobs and the oval-head bolts
from the upper handle section.
3. Install the upper handle section onto the lower
handle section with the oval-head bolts and the
5
Use
Figure 3
4. Lower handle section
5. Handle height adjustment
knob (2)
6. Handle height settings