Choke
Primer (start aid)
Push primer three times.
Properly dispose of
batteries.
Insert key in ignition
switch.
Assembly
Note: Determine the left and right sides of the lawn mower by standing in the operating position.
Unpacking the Lawn Mower
IMPORTANT:
Be extremely careful when unpacking
and handling the lawn mower and upper handle so that
you do not pull, crimp, or damage the cables.
1. Remove the fillers from the box, and allow the upper
handle to rest on the top of the lawn mower.
2. Remove the lawn mower from the box.
3. Lay the upper handle on the ground behind the lawn
mower with the handle label facing up and the control
cables routed between the handle mounting brackets.
Installing the Handle
1. Remove the four handle bolts and knobs in the lower
handle (two bolts have a flat cap and the other two
have a contoured cap to fit the handle (Fig. 2).
Turn key in ignition
switch.
Move control.
Pull rope.
Wheel
Wheel traction
1
4
2
1. Lower handle
2. Support bracket
2. Swing the lower handle back and the support brackets
up, aligning the brackets with the holes in the handle
(Fig. 2).
7
3
Figure 2
3. Knob
4. Flat handle bolt
m–4272