Power On/Off; Iec Power Connector; Fuse Holder - KRK 8S User Manual

[10] SUB & HPF BYPASS (FOOTSWITCH) [Footswitch not included]
There may be times where an engineer or producer will want to hear a mix only through their studio monitors without
the studio subwoofer engaged. The KRK 8s/10s/12s studio subwoofer comes with an input for connecting an optional
momentary footswitch (not included) to control this function. When the switch is activated, the subwoofer will mute
and a full‐range signal will be sent through the outputs to the connected studio monitors.
[11] POWER/STAND‐BY LIGHT
This light is green when the subwoofer is on and will turn orange once it falls into STANDBY mode.
[12] POWER ON/OFF
The switch for turning ON a KRK 8s/10s/12s studio subwoofer is located on the back panel below the audio inputs, audio
outputs, and power/standby control.
[13] IEC POWER CONNECTOR
A standard IEC‐type AC Inlet Socket is used to provide power to the subwoofer. Be sure to use the power cord that is
included with the product and contact your retailer or distributor if it is missing when purchasesd.
[14] FUSE HOLDER
Under normal operation the fuses should not blow. A blown fuse usually indicates an overload or fault condition. To
change the fuse, remove the power cord, pry off the fuse block with a small flathead screwdriver and change the blown
fuses.
NOTE: If the fuses blow immediately upon power up, this indicates a fault condition and the monitor should be returned
to KRK for repair.