Toro Wheel Horse XL380H 71252 Operator's Manual page 30

1. Idler spring
2. Eye-bolt
8. Remove the bolts and lock nuts and pull the two
mower pivot mount brackets down from the front
axle (Figure 39).
1. Pivot mount bracket
2. Bolt (5/16 x 2-1/2 inch)
9. Remove the hairpin cotter and washer from the end
of the long rod (Figure 40). Slide the rod out of the
mower mount.
1. Hairpin cotter and washer
2. Long rod
10. Remove the hairpin cotter and washer at the mower
leveling bracket (Figure 40). Slide the bracket off of
Figure 38
3. Idler arm
4. Idler pulley
Figure 39
3. Locknut
Figure 40
3. Leveling bracket
4. Mower mount
the mounting pin. Install the washer and hairpin
cotter for storage.
11. Rotate the leveling bracket up toward the frame, and
hook the long rod into one of the holes to store.
Secure the long rod with the washer and hairpin
cotter.
12. Repeat 9 through 11 on the opposite side of the
mower.
13. Move the height-of-cut lever into the "D" notch.
Hook the lift assist spring onto the retaining bolt
for storage (Figure 37).
14. Remove the mower belt from the electric clutch
pulley (Figure 41).
1. Mower belt
15. Remove the mower belt from the lower engine pulley
(Figure 41).
16. Turn the front wheels fully to the left. Slide the
mower out to the right to complete removal.
30
Figure 41
2. Electric clutch pulley