Page 1
Form No. 3367-140 Rev C XLS 380 and XLS 420T Lawn Tractors Model No. 71254—Serial No. 311000001 and Up Model No. 71255—Serial No. 311000001 and Up Setup Instructions Loose Parts Use the chart below to verify that all parts have been shipped.
Page 2
Figure 2 1. Flat washer 3. Hub cap 2. Cotter pin G017999 Figure 1 Note: If the cotter pin does not fit, remove the 1. Negative battery cable 4. Negative battery post cap shim washer(s) as needed. 2. Locknut 5. Carriage bolt 5.
Page 3
Figure 3 Figure 4 1. Steering wheel 2. Spirol pin 1. Seat 4. Seat switch 2. Shoulder bolts 5. Seat base 3. Knobs and flat washers Note: From the seat you should be able to easily read the brand logo on the steering wheel. 2.
Page 4
Installing and Adjusting the Test Driving the Tractor Mower No Parts Required Parts needed for this procedure: Procedure Mowing deck To ensure that all electrical and mechanical systems are operating properly, see the Operator’s Manual. Procedure Install the mowing deck and adjust both the side-to-side level and the front-to-rear blade slope.