Table of Contents
Advertisement
Figure 25
1. Hose clamp
2. Fuel line
6. Squeeze the ends of the hose clamp together
and slide it up the fuel line toward the fuel tank
(Figure 25).
7. Pull the fuel line off of the fuel filter (Figure 25)
and allow gasoline to drain into a fuel container or
a drain pan.
Note: Now is the best time to install a new fuel
filter because the fuel tank is empty.
8. Install the fuel line onto the fuel filter.
9. Slide the hose clamp close to the fuel filter to secure
both the fuel line and the fuel filter.
Replacing the Fuel Filter
Service Interval: Every 100 hours—Replace the fuel
filter.
The best time to replace the fuel filter (Figure 25) is
when the fuel tank is empty. Never install a dirty fuel
filter after it has been removed from the fuel line.
1. Disengage the blade control (PTO) and set the
parking brake.
2. Stop the engine, wait for all moving parts to stop, and
remove the key before leaving the operating position.
3. Open the hood.
4. Squeeze the ends of the hose clamps together and
slide them away from the fuel filter (Figure 25).
5. Remove the fuel filter from the fuel lines.
6. Install a new fuel filter and move the hose clamps
close to the fuel filter.
7. Close the hood.
3. Fuel filter
Electrical System
Maintenance
Servicing the Battery
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery and battery box. If
the battery terminals are corroded, clean them with a
solution of 4 parts water and 1 part baking soda. Apply
a light coating of grease to the battery terminals to
prevent corrosion.
Battery voltage and amperage: 12 volts, 155
cold-cranking amps
Removing the Battery
Battery terminals or metal tools could short
against metal tractor components, causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
• When removing or installing the battery, do
not allow the battery terminals to touch any
metal parts of the tractor.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
tractor.
1. Disengage the blade control (PTO) and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Tip the seat forward to see the battery.
4. Disconnect the negative (black) ground cable from
the battery post (Figure 26).
23
Hide quick links:
Advertisement
Table of Contents
