Table of Contents
Advertisement
8. Place the second bushing into the wheel hub (Fig. 51).
9. Install the wheel spacers on the outside of the
bushings, then install the castor wheel into the castor
fork (Fig. 51).
10. Secure the castor wheel to the castor fork with the
wheel bolt and locknut. Tighten the locknut until the
spanner bushing bottoms against the inside of the
castor fork (Fig. 51).
11. Grease the fitting on the castor wheel.
Removing the Discharge Cover
for Discharge Mowing
Danger
Without the grass deflector, discharge cover, or
complete grass catcher assembly mounted in
place, you and others are exposed to blade contact
and thrown debris. Contact with rotating mower
blade(s) and thrown debris will cause injury or
death.
•
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the mower.
•
Never try to clear discharge area or mower
blades unless you move the blade control switch
(PTO) to the Off position and rotate the
ignition key to the Off position. Also remove the
key and pull the wire off the spark plug.
1. Disengage the blade control (PTO), set the parking
brake, stop the engine, remove the key, and disconnect
the spark plug wire from the spark plug.
2. Thoroughly clean the mower.
3. Raise the grass deflector and remove the chute pin on
the front of the discharge cover (Fig. 52).
1
3
4
5
Figure 52
1. Grass deflector
2. Chute pin
3. Locknut, 5/16 inch
4. Flat washer
4. Remove the locknut, flat washer, and bolt (5/16 x
1-1/4 inch) holding the top of the discharge cover to
the top of the mower (Fig. 52).
5. Remove the locknut, flat washer, and bolt (5/16 x
2-1/4 inch) holding the loop on the rear of the
discharge cover to the deck ring (Fig. 52).
6. Remove the discharge cover from the mower (Fig. 52).
Warning
Open holes in the mower could allow the mower
to throw objects in the operator's or bystander's
direction and result in serious injury.
Never operate the mower with open holes; install
hardware in all open mounting hole when you
remove the discharge cover.
7. Install the bolt (5/16 x 1-1/4 inch), flat washer, and
locknut removed in step 4 into the open hole in the top
of the mower for safety.
34
2
3
4
7
6
m-2630
5. Bolt, 5/16 x 2-1/4 inch
6. Bolt, 5/16 x 1-1/4 inch
7. Discharge cover
Advertisement
Table of Contents
