Adjusting The Discharge Chute Latch; Replacing The Drive Belts; Replacing The Headlight Bulb - Toro Power Max 828LE Operator's Manual

Note: If you do not have a torque wrench, tighten
the plug firmly.
Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge chute latch.
1. Remove the fastener on the gear cover (Figure 47), lift
the front of the cover up, and slide it back and out of
the way.
Figure 47
2. Loosen the bolt on the cable clamp (Figure 48).
Figure 48
1. Cable conduit
3. Grasp the cable conduit and move it toward the front of
the machine until the discharge chute latch fully engages
the gear teeth (Figure 48 and Figure 49).
Figure 49
1. Discharge chute latch
2. Cable clamp
2. Gear teeth
Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 49).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go to
www.Toro.com for additional service information or have
an Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 892 16W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 50).
Figure 50
2. Turn the base of the bulb counterclockwise until it
stops (Figure 51).
Figure 51
3. Remove the bulb straight out from the back of the
headlight (Figure 52).
19