Panasonic DMC-FT6 Basic Operating Instructions Manual page 13

Hide thumbs Also See for DMC-FT6:
Table of Contents

Advertisement

2
Drain water by holding the camera
upside down and shaking it lightly a few
times.
Make sure to put your hand through the strap
to prevent the camera from falling.
3
Wipe off water drops on the camera with a
soft, dry cloth and dry the camera in a
shaded area that is well ventilated.
Dry the camera by standing it on a dry cloth.
This unit incorporates drain design, draining
water in gaps in the camera [ON/OFF] button
and zoom button etc.
Do not dry the camera with hot air from dryer
or similar. Waterproof performance will deteriorate due to deformation.
Do not use chemicals such as benzine, thinner, alcohol or cleanser, soap or
detergents.
4
Confirm that there are no water droplets, open the side door, and wipe off
any water droplets or sand left inside using a soft, dry cloth.
Water droplets may adhere to the card or battery when the side door is opened without
thoroughly drying. Also, water may accumulate in the gap around the card/battery slot
or the terminal connector. Be sure to wipe any water off with a soft, dry cloth.
The water droplets may seep into the camera when the side door is closed while it is
still wet, causing condensation or failure.
13
(ENG) SQT0840

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents