Connecting The Units; Connecting To Separately Sold Power Amp; When Connecting With A Multi-Channel Processor - Pioneer DVH-P4100UB Installation Manual

Connecting the Units

Connecting the Units

Connecting to separately sold power amp

Front output
Rear output
This product
Blue/white
Connect to system control terminal of the
power amp (max. 300 mA 12 V DC).
Blue/white (7*)
Blue/white (6*)
Connect to auto-antenna relay control
terminal (max. 300 mA 12 V DC).
The pin position of the ISO connector will
differ depends on the type of vehicle.
When you connect separately sold multi-channel
Connect 6* and 7* when Pin 5 is an
processor (e.g. DEQ-P6600) to this unit, do not
antenna control type. In another type of
connect anything to the speaker leads and system
vehicle, never connect 6* and 7*.
remote control (blue/white).
Note:
When you connect multi-channel processor to
this unit, separately sold power amp must be
connected to multi-channel processor.
Connect with RCA cables
(sold separately)
Power amp (sold
separately)
Power amp (sold
separately)
System remote control
Left Right
+ +
Front speaker
Front speaker
≠ ≠
+ +
Rear speaker Rear speaker
≠ ≠
Perform these connections when
using the optional amplifier.

When connecting with a multi-channel processor

1.5 m
AV system display
RCA cable
To video input
(supplied)
Video output
(VIDEO OUTPUT)
This product 15 cm
Black
Blue
DEQ output
Blue Optical cable connection
box (supplied with multi-
channel processor)
RCA cable
(supplied with multi-
channel processor)
Optical cable
(supplied with multi-
IP-BUS cable
channel processor)
(supplied with multi-channel
processor)
Blue
Multi-channel processor
(DEQ-P6600)
(sold separately)
Black
Connecting and installing the Installing the optical cable
optical cable connection box
connection box
• When installing the optical cable
WARNING
• Avoid installing this unit in locations where the connection box with the hook and
operation of safety devices such as airbags is pre-
loop fastener.
vented by this unit. Otherwise, there is a danger of
Install the optical cable connection box
a fatal accident.
using the hook and loop fastener in the
• Avoid installing this unit in locations where the
operation of the brake may be prevented. ample space of the console box.
Otherwise, it may result in a traffic accident.
• Fix this unit securely with the hook and loop fas-
tener or lock tie. If this unit is loose, it disturbs dri-
ving stability, which may result in a traffic acci-
dent.
CAUTION
• Install this unit using only the parts supplied with
this unit. If other parts are used, this unit may be
damaged or could dismount itself, which leads to
an accident or other problems.
• Do not install this unit near the doors where rain-
water is likely to be spilled on the unit. Incursion
• When installing the optical cable
of water into the unit may cause smoke or fire.
Black connection box with the lock tie.
Connecting the optical cable
Wrap the optical cable and connection
box with the protection tape and fasten
1. Connect the optical cable and
with the power code using the lock tie.
ground lead to the main unit.
Connect the optical cable so that it does
not protrude from the unit, as shown in
the illustration. Fasten the ground lead
to the protrusion on the back of the
unit.
Fasten with the lock tie
Screw
2. Connect the optical cable to the
optical cable connection box.
Optical cable
<ENGLISH> <ENGLISH>
Hook fastener
Loop fastener
Wrap with the protection tape