Fell Marine WiMEA User Manual page 15

In the event you as the driver need to exit the boat while mooring
or performing other tasks you can engage Moor Mode. WiMEA will
be in standby for 2 minutes, allowing you to go out of wireless
range without the engine stopping.
1.
2.
3.
4.
5.
6.
NOTICE
Moor Mode
Engage Moor Mode
Start with being connected to the Boat Unit
with your MOB Unit.
Press & Hold the button on the MOB Unit for at
least 3 seconds.
The Boat Unit will flash a yellow light and sound
a signal every 2 seconds. You are now in Moor
Mode.
The Moor Mode will time-out after 2 minutes.
If you are within wireless range of your Boat
Unit the system will automatically reconnect
to the MOB Unit. If you are outside the range
(normally 30 feet (10 m) or more)of your Boat
Unit, the system will shut down the engine to
prevent the engine from running
unintentionally.
Exit Moor Mode by clicking once on the MOB
Unit while Moor Mode is active and your MOB
Unit is within 30 feet (10 m) from your boat.
This will disconnect the system.
The Moor Mode assists you as the driver when in
need to go out of range, but still need to have
the engine running. This can be very helpful when
operating a boat alone, and in the need to do
cordage back and forth while mooring. In the
event that you would fall overboard while in Moor
Mode, the system will stop the engine after 2
minutes or if Moor Mode times out.
15