Advertisement
Performing a Factory Reset of your 9300-RADES
The 9300-RADES offers two levels of reset. The first level resets the IP address
only, the second level resets all of the settings to default
Materials Needed:
- Small Screwdriver or paper clip
- AC power supply included with the modem kit
● Resetting the IP address only (Sets RADES to 192.168.1.1/255.255.255.0)
1. Leave power applied to the modem
2. Remove the plastic clip located on the back of the unit. To do this use a
small screwdriver to lift the center snap carefully and slide the clip up to
remove.
3. Locate the Yellow Reset button in the right clip slot. The button will be
towards the bottom of the slot.
4. Press the yellow button with a small screwdriver or paperclip and hold until
the LEDs on the front of the unit move in a circular pattern.
5. Cycle power and the IP address will be set back to default
!
Use care when inserting screwdriver to prevent damage to the
modem or shock.
BACK
8
Advertisement
