Advertisement
Setting up the 9300-RADES for an Ethernet Connection
1.
The 9300-RADES has a default IP address:192.168.1.1 subnet mask:
255.255.255.0
2.
On your PC, select
Connection.
3.
Click on the
4.
Highlight
Internet Protocol (TCP/IP)
5.
Enter an IP address and Subnet Mask on the same network as the
RADES; make sure that this address is not used by anything else on the
network. Do not use 192.168.1.2 (See note below for explanation)
6.
Open your browser window and enter
7. The Web Browser username:
be changed under Set Security.
PLEASE NOTE:
The 9300-RADES uses three IP addresses when a modem
connection is made. One for the management interface (192.168.1.1 by default),
One for the PPP Client traffic (Assigned in Step 5 above), and one for the PPP
server traffic (Always the management interface IP plus 1, 192.168.1.2 by
default). Do not use these three IP addresses for any other nodes on the
network.
Troubleshooting:
If your browser window will not open:
1. Make sure you do not have a proxy server in place; if so, disable it.
2. Make sure that your IP address is correct.
3. Make sure you did not change the IP address with a bootp server or
DHCP server.
4. Make sure the RADES has power.
5. Make sure that you have a lit LED on the connected Ethernet port of the
RADES and your computer's Ethernet port. If not lit, this indicates an
Ethernet cable issue.
If modem will not connect:
1. Check to ensure that the phone line is one continuous cable (no spliters
or couplers).
2. Make sure you are dialing the correct phone number.
3. Check your username and password (username: ppp_user password:
ZYPCOM by default).
Start>Settings>Network Connections>Local Area
properties button
Admin
and click on the
Properties button
192.168.1.1
and password:
ZYPCOM
this can
BACK
4
Advertisement
