Advertisement
Upgrading your 9300-RADES
!
1. Open a DOS prompt and type
2.
The FTP username is: uploader, password:
This can be changed under
3.
Use the Put command to send the firmware file to the modem. Type:
put File Path\boot.img
4.
The modem will update and power cycle automatically to complete the
flash procedure.
your Ethernet Switch during this procedure.
!
Do not cycle power during the flash procedure. The unit will
automatically power cycle when the flash procedure completes. If
power is lost before this point, the unit may be rendered
inoperable.
5.
Re-establish your FTP session (Steps 2 and 3)
6.
Use the Put command to send the Web browser data file to the
modem. Type:
Note:
boot.img and webdata.img filenames will always be the same; the name
does not change with the firmware revision. Therefore, once the upgrade
process is complete it is important to check the firmware version on the
RADES home page.
Note:
Flashing the unit does not wipe out your IP address or passwords.
* To access RADES home page see the directions for establishing an Ethernet
connection or a modem connection.
Attention:
Do not Upgrade a 9300-RADES on a running
system, this procedure requires a power cycle. Ethernet
communications will be lost for about 60 seconds.
Basic Configuration>Set Security.
Please note that you will lose communications on
put File Path\webdata.img
ftp 192.168.1.1
(IP address may vary)
ZYPCOM
by default.
BACK
7
Advertisement
