Table of Contents
Advertisement
DVD
CD
Basic playback
This owner's manual explains the basic instructions of this unit. Some DVD discs are produced
in a manner that allows specific or limited operation during playback. As such, the unit may not
respond to all operating commands. This is not a defect in the unit. Refer to the instruction notes
of discs.
"
" may appear on the screen during operation. A "
is not permitted by the unit or disc.
Playing a Disc
1. Slide the POWER ON/OFF button on the left side of unit into on mode.
2. Slide the FUNCTION button on the right side of unit to select DVD mode.
See CUSTOMIZING THE FUNCTION SETTINGS (page 24 to 27) before proceeding to step 3.
3. Slide the OPEN button on the left side of unit to open the disc door.
4. Hold the disc by its sides and carefully make it fit onto the central support of compartment with the label side
facing up until you hear a "click".
5. To close the disc door, push the door where "to close" is printed. It will take a short while for your unit to load the
disc: some disc might start automatically.
6. Press the
PLAY button.
Pausing playback (still mode)
Press the II PAUSE button. To resume normal playback, press the
Stopping playback
Press the
STOP button at the location where you want to interrupt playback. To resume playback at the position
where the disc was stopped, press the
If you press the
STOP button twice, the unit's memory will be cleared and pressing the
the disc to the beginning.
To skip to a different track
• Press the
PREV button repeatedly to skip to the start of the current or previous track.
• Press the
NEXT button to skip to the next track.
• For audio CD disc, use the number buttons (remote control only) to jump straight to that track number.
PLAYING A DISC
PLAY button.
E - 15
" means that the desired operation
PLAY button.
PLAY button will reset
(continued to next page)
(continued to next page)
(continued to next page)
(continued to next page)
(continued to next page)
Advertisement
Table of Contents
